Results 1 to 2 of 2

Thread: Computer upgrade advice?

  1. #1
    Join Date
    Nov 2021
    Posts
    1

    Computer upgrade advice?

    Hi, friends. I could use some advice on the right computer for Sketchup/CAD. My wife's a landscape-architect-in-training who's doing a lot of Sketchup and AutoCAD at home. Her computer is slow, but then I understand that pretty much ALL 3D design work can bog down the best computers, so we're wondering whether we can actually improve things without dropping thousands on a custom build.

    We're looking at a specific, relatively inexpensive Beelink box as a possible upgrade, and wondering whether it's (a) adequate, and (b) would be a noticeable improvement over her current laptop. If not, what WOULD folks recommend for a reasonable price?
    Here are the specs for the two computers (current and prospective):

    Current: Lenovo Ideapad 330-17IKB:
    Intel Core i5-9250U (4 cores, 8 threads, 1.6-3.4 GHz, 6 MB smart cache)
    Intel® UHD Graphics 620 (integrated, not a separate card)
    500 GB HDD
    12 GB RAM (maxed out)
    https://support.lenovo.com/us/en/sol...view-330-17ikb and https://ark.intel.com/content/www/us...-3-40-ghz.html and https://psref.lenovo.com/syspool/Sys...17IKB_Spec.PDF

    Proposed: Beelink SER3 Mini PC:
    AMD Ryzen 7-3750H (4 cores, 8 threads, 2.3GHz base, boost max 4.0 GHz, 4MB smart cache)
    Radeon RX Vega 10 graphics (integrated, not a separate card)
    500GB SSD
    16 MB RAM (room to upgrade to 32)
    https://www.bee-link.com/products/ser-37580h

    Thanks!!!

  2. #2
    Join Date
    Jan 2008
    Location
    English Lake District
    Posts
    2,942
    I was about to point you to CadTutor which is a much more active forum than here, but I see that you have already found it and asked the same question there.

    Cad64 has already answered you over there.
    (He's been around for a while and was one of the moderators on this forum when it was more active).
    Im intelligent enough to know that I dont know everything; but I'll tell you all about it anyway.

Similar Threads

  1. Press pull constraint advice
    By Doug Hole in forum AutoCAD 2019 Help
    Replies: 0
    Last Post: 27-07-2021, 06:41 PM
  2. New to Cad need advice and help
    By Stargazer in forum Open CAD Discussion
    Replies: 4
    Last Post: 20-03-2013, 09:59 AM
  3. Drafting Board Advice
    By Plotter Guy in forum Open CAD Discussion
    Replies: 4
    Last Post: 13-09-2008, 07:30 PM
  4. Seeking Advice
    By Graham Matson in forum Other CAD Software
    Replies: 6
    Last Post: 12-09-2008, 12:36 AM
  5. island hatch advice
    By shelly in forum AutoCAD 2006 Help
    Replies: 3
    Last Post: 27-01-2006, 09:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •